Met and Mat Trans Contents A: November 1994

METALLURGICAL AND MATERIALS TRANSACTIONS A

TABLE OF CONTENTS Volume 25A, No. 11, November 1994 This Month Featuring: Alloy Phases; Transport Phenomena; Mechanical Behavior; Environment; Welding and Joining; and Solidification.

METALLURGICAL AND MATERIALS TRANSACTIONS A

TABLE OF CONTENTS
Volume 25A, No. 11, November 1994

This Month Featuring: Alloy Phases; Transport Phenomena; Mechanical Behavior; Environment; Welding and Joining; and Solidification.

Alloy Phases

Microstructure and Sound Velocity of Ti-N-O Synthetic Inclusions in Ti-₆Al-₄V [pp. 2321-2329]
M.F.X. Gigliotti, R.S. Gilmore, and L.C. Perocchi

Thermodynamic Analysis of the In-Ga-Sb System [pp. 2331-2340]
Teng-Chien Yu and Robert F. Brebrick

Communication: Discussion of "Crystallographic Characterization of the Al-Co Decagonal Quasicrystal and its Monoclinic Approximant 2-Al₁₃Co₄" [pp. 2535-2536]
B. Grushko and C. Freiburg

Communication: Author's Reply [pp. 2536-2538]
X.L. Ma and K.H. Kuo

Communication: Improved Thermochemical Calculations for Maraging Steels and Comparison with Atom Probe Measurements of Phase Composition [pp. 2538-2539]
W. Sha and G.D.W. Smith

Transport Phenomena

Evolution of Interaction Domain Microstructure during Spray Deposition [pp. 2341-2355]
X. Liang and E.J. Lavernia

Modeling the Infiltration Kinetics of Molten Aluminum into Porous Titanium Carbide [pp. 2357-2370]
Daniel Muscat and Robin A.L. Drew

Mechanical Behavior

The Effect of Thermal Exposure on Microstructural Stability and Creep Resistance of a Two-Phase TiAl/Ti₃Al Lamellar Alloy [pp. 2371-2381]
Michael F. Bartholomeusz and John A. Wert

Modeling the Effects of Stress State and Crystal Orientation on the Stress-Induced Transformation of NiTi Single Crystals [pp. 2383-2389]
T.E. Buchheit and J.A. Wert

Effect of Fe on the Superplastic Deformation of Zn-22 pct Al [pp. 2391-2401]
Prabir K. Chaudhury, Kyung-Tae Park, and Farghalli A. Mohamed

Micromechanical Modeling of Reinforcement Fracture in Particle-Reinforced Metal-Matrix Composites [pp. 2403-2420]
M. Finot, Y.-L. Shen, A. Needleman, and S. Suresh

Short Fatigue Crack Growth Behavior in a Ferritic-Bainitic Steel [pp. 2421-2425]
K. Hussain, A. Tauqir, F.H. Hashmi, and A.Q. Khan

Evaluation of Static and Dynamic Fracture Toughness in Ductile Cast Iron [pp. 2427-2437]
Toshiro Kobayashi and Shinya Yamada

Fracture Toughness of Quaternary Al-Li-Cu-Mg Alloy under Mode I, Mode II, and Mode III Loading Conditions [pp. 2439-2452]
N. Eswara Prasad, S.V. Kamat, G. Malakondaiah, and V.V. Kutumbarao

The Influence of SiC Particulates on Fatigue Crack Propagation in a Rapidly Solidified Al-Fe-V-Si Alloy [pp. 2453-2460]
T.J. Sutherland, P.B. Hoffman, and J.C. Gibeling

Fracture Toughness of Discontinuously Reinforced Al-4Cu-1.5Mg/TiB₂ Composites [pp. 2461-2468]
N.C. Beck Tan, R.M. Aikin, Jr., and R.M. Briber

Low Cycle Fatigue Behavior of Polycrystalline Ni₃Al Alloys at Ambient and Elevated Temperatures [pp. 2469-2476]
Graham Webb and Stephen D. Antolovich

Creep Characteristics of Single Crystalline Ni₃Al (Ta,B) [pp. 2477-2482]
J. Wolfenstine, H.K. Kim, and J.C. Earthman

The Study of Adiabatic Shear Band Instability in a Pearlitic 4340 Steel Using a Dynamic Punch Test [pp. 2483-2489]
Anna K. Zurek

Communication: Load-Signature Analysis for Pack Rolling of Near-Gamma Titanium Aluminide Alloys [pp. 2539-2542]
S.L. Semiatin and V. Seetharaman

Environment

High-Temperature Oxidation of Cathodically Hydrogen-Charged Two-Phase (Ti₃Al, TiAl) Titanium Aluminides [pp. 2491-2496]
Akito Takasaki, Kozo Ojima, and Youji Taneda

Welding and Joining

Spreading and Interlayer Formation at the Copper-Copper Oxide/Polycrystalline Alumina Interface [pp. 2497-2506]
M.D. Baldwin, P.R. Chidambaram, and G.R. Edwards

Solidification

Undercooling-Induced Macrosegregation in Directional Solidification [pp. 2507-2516]
Henry C. de Groh III

Nonequilibrium Solidification of Undercooled Melt of Ag-Cu Alloy Entrained in the Primary Phase [pp. 2517-2523]
O.P. Pandey, N.S. Mishra, C. Ramachandra, S. Lele, and S.N. Ojha

Melt-Processed Ni₃Al Matrix Composites Reinforced with TiC Particles [pp. 2525-2534]
S. Sen, D.M. Stefanescu, and B.K. Dhindaw

Communication: Precipitation of BCC Phase from Nonequilibrium A13-Type Phase in Rapidly Solidified High-Carbon Fe-Cr-Mo Alloy [pp. 2542-2546]
H. Era, P. Li, and K. Kishitake

Direct questions about this or any other Metallurgical and Materials Transactions page to mettrans@andrew.cmu.edu.

Search TMS Document Center Tables of Contents Subscriptions Met. and Mat. Trans. TMS OnLine